Item Description

CZPT Taper Lock Bush

The Taper Lock bush is a locking system typically utilised in Power Transmission Drives for locating pulleys, sprockets,  and couplings to shafts. The Taper Lock bush is pre-bored and keyed to match the required shaft and keyway diameters.  The outside of the bush is tapered to match the ingredient bore that is to be found on the shaft.
 
CZPT Taper bushes is manufactured from precision forged iron or carbon steel C45 with higher good quality finish.  They are commonly used to fit into Sheaves, Sprockets, Pins, V-belt Pulleys and Timing Pulleys.

 
Features : 
·         No require for re machining.
·         No corrosion amongst bore and shaft.
·         Simple-On/Easy-Off
·         Substance in Metal and cast iron are obtainable
 
Sorts of Taper Bushings are offered:
·         ANSI Split Taper Bushings
·         ANSI Taper Bore Bushings
·         ANSI QD Bushings
 
1008, 1108, 1210, 1215, 1310, 1610, 1615, 2012, 2517, 2525, 3571, 3030, 3535, 4040, 4545, 5050

Taper lock bushing dimensions are defined by 4 digits symbolizing two numbers. The initial two digits depict the maximum bore diameter and the very last two digits represent the bushing length. For example, portion quantity 1008 has a optimum ID of 1.” and an ID measurement of .8″ inches, with the total length specified as a complete quantity of inches adopted by a portion. For case in point, a 1.5″ diameter gap would be 1-1/2. Metric hole measurements are indicated by “MM” after the metric measurement (X 25MM). Effortless to set up and remove, these bushings match on tapered bushing sprockets, or pulley. Bushing touches and wedges inwards, clamping sprocket shaft and bore. Bushing has an 8° taper and is manufactured of metal with a black oxide coating.