Set up 1.1. Clean all oil, dust and paint from shafts, bushing holes, bushing exterior and holes of components (sprockets, pulleys, and so forth.). Insert the bushing into the assembly. 3. Match the pattern of holes, not threaded holes (each and every hole is threaded on one particular side only). Insert the socket head cap screws or screws into the 50 %-threaded holes shown in the picture under. Set up the assembly on the shaft. 4. Convert the torque setting or include screw* to the advised torque location in the diagram underneath. Fill any unfilled holes with grease.
Taper lock bushing dimensions are described by 4 digits symbolizing two figures. The first two digits depict the greatest bore diameter and the final two digits represent the bushing length. For example, portion variety 1008 has a highest ID of 1.” and an ID measurement of .8″ inches, with the overall duration specified as a entire quantity of inches followed by a portion. For example, a 1.5″ diameter hole would be 1-1/2. Metric hole dimensions are indicated by “MM” following the metric measurement (X 25MM). Simple to install and remove, these bushings fit on tapered bushing sprockets, or pulley. Bushing touches and wedges inwards, clamping sprocket shaft and bore. Bushing has an 8° taper and is made of steel with a black oxide coating.